Showing posts with label pond waterfalls. Show all posts
Showing posts with label pond waterfalls. Show all posts

Thursday, April 19, 2012

How to Build a Waterfall

Sometimes when the day is busy or the mind is on vacation, I find it a good idea to rerun a post that was widely read the first time.
Today is one of those days.
So here is a post on how to build a waterfall from way back in 2006.



Building a waterfall is either simple or difficult depending on the point of view of the builder. We want them to look natural, like they just started happening in the rocks of our gardens, never mind that we had to buy the rocks because we live where no rock has ever been found like New Orleans where I live.

The easiest way to have a waterfall is to use a weir. A weir is a box that collect water that the pump has pumped into it. One side of the box is lower than the rest and has a lip on it so water will go over it.
These can be effective when building a waterfall. Simply elevate them above your pond, usually positioning them level on the dirt you have dug out to make your pond, put tubing from your pump in the weir.When the weir fills up, a sheet of water will fall over the weir and into your pond. You can hide the weir with rocks so no one can see the plastic box. Also, if you have a biofilter, you can put it in the weir. As an aside, if you do have a biofilter and use lava rocks in it, put them in several mesh bags, not just one. It takes several strong men to lift just one bag out, so use at least three. I usually float some hyacinths or other floating plants in the weir to further camouflage the plastic box.


Another, and my favorite way, is to start with a semi level surface, slightly raised in the back, starting at the same level as your pond. From there build the waterfall using the same kind of rocks you used in your pond construction. Start with large, flat and thin rocks. You can’t build a waterfall with round rocks or little ones either. After you put the first large rock down, run a hose over it to make sure the water flows into the pond. If it does not, shim up the back of the rock. If you don’t start on a slight angle, water will fall off the back and drain your pond dry in a few hours. Next, stack two or three thick and chunky rocks on each end of the bottom rock. Those rocks can be as much as 5 or 6” thick. Make sure they are flat on two sides because you are going to build the rest of your waterfall on top of them. If you have two large flat rocks on the ground level, you need more chunky rocks to rest the second level on. 

Next place the second level of flat, thin and large rocks on the chunks. Again run water over to make sure the flow is going in the pond and not over the edge. Continue making levels until you like your waterfall or run out of rocks. Make your waterfall as wide as you wish, remembering that you may need more than one pump.

I have found that the easiest way for me to build the falls is for me to be in the water and have a couple of strong helpers placing rocks for me. 

The back of the falls is equally important. Shimming must be done to keep the angle toward the pond and proper placement of rocks is most important to ensure stability of the falls. 




You can buy my Pond how-to book here

It is consistently in the top ten best sellers in Landscaping. 
It's on sale now for a buck.  Get it before the price goes back up.


And for pond info visit us at pondlady.com  You will find knowledgeable folks there who are glad to answer your questions.

Thank you for stopping by this morning.